Features and Benefits
- Century 80 GL welds 18 ga. sheet metal up to 1/8” steel
- Great for general purpose metal repair and building projects
- Two separate heat settings and an infinite wire speed control
- Uses 0.035 flux core welding wire on a 4” spool. No shielding gas needed (ED027641)
- Plugs into a standard 120 volt AC household outlet. No special wiring or receptacle needed
- Safe cold wire design. Arc is not established until trigger is pulled
- Sturdy wire feed design and multi-insulated transformer for reliable operation and long life
- Heat Range Switch
- Wire Speed Control
- Operates on 115 volt input
- Solid state output control
- Overload protection - incorporates a thermostat to protect the welder from overheating caused by malfunctions or overly heavy use
- Permanent magnet wire drive motor
- Easy-to-set controls for arc voltage and wire speed
- Thumbscrew release idle roll pressure arm is easily adjusted
- Reversible, dual groove drive roll
- Accommodates spools of wire up to 1 lbs(0.5 kg) in weight
- No external shielding gas is required
- The machine is rated at 70 amps, 17 volts, at 20% duty cycle on a ten minute basis
- It is capable of higher output currents at lower duty cycles
Product Information
-
Specifications